Code blocks not aligning

I have five code blocks lined up, with lottie files in each one. The first code block is too big, and even if I change the size width-wise or height-wise, it stays larger than the other blocks (you can see the Photography lottie file touches the edge of the section line, and the rest of them are a bit offset up from it.  All the codes in each block are exactly the same, with different lottie files referenced. The lottie files themselves were built by me, and they're all the same size, font in the same location, etc. I'm pulling my hair out!!

Please see the following.

I tried to do this, make the columns divisible by 12. I had 2 spacer blocks, so reduced it to one, leaving 6 columns. This did not solve the problem, the first "Photography" lottie file is still larger than the rest for some reason. Any other suggestions?

Please post the URL for a page on your site where we can see your issue.

If your site is not public please set up a site-wide password, if you've not already done so.

Post the password here.

Adding a site-wide password does not allow anyone to alter your site. It only allows those with the password to see your site. Please read the documentation at the link provided to understand how it works.

Please read the documentation at the link provided on how to share a link to your site to understand how it works. A link to the backend of the your site won’t work for us, i.e. a url that contains /config/.

We can then take a look at your issue.

Site is https://www.thecolorcrew.com/home-041322

Password is Blender76

20 hours ago, creedon said:

Please post the URL for a page on your site where we can see your issue.

If your site is not public please set up a site-wide password, if you've not already done so.

Post the password here.

Adding a site-wide password does not allow anyone to alter your site. It only allows those with the password to see your site. Please read the documentation at the link provided to understand how it works.

Please read the documentation at the link provided on how to share a link to your site to understand how it works. A link to the backend of the your site won’t work for us, i.e. a url that contains /config/.

We can then take a look at your issue.

Hopefully I did that right!